Motorcyclists are being urged to slow down at roadworks on the Oxley Highway, NSW, between Mount Seaview and Gingers Creek where lower rub rails are being installed. Transport for NSW Director North Region Anna Zycki says road crews are installing new guardrails and crash barriers and repairing drainage on the mountain section of the highway where the speed limit was controversially reduced to 80km/h in 2018. “Work on the guardrail involves installing an extra protection rail below the existing guardrail and is designed to stop bikers involved in a crash from sliding into the steel posts,” she says. “Crash barriers are proven to keep vehicles from crashing down embankments and into trees but their posts can be unforgiving if a motorcyclist loses control and slides into them. “Unfortunately some riders have been ignoring temporary traffic lights set up to ensure the safety of road users and workers while these upgrades are under way. “Our road crews have also reported riders speeding up to beat the orange light and speeding close by workers on the road.” Ms Zycki says the installation of the protection rail follows consultation with “key motorcycle groups”. Slow down for roadworks “It’s disappointing to find some riders are putting in danger the teams who are working hard to provide them with extra protection along this popular route,” she says. “All road users are urged to drive or ride to the conditions, and follow the directions of signs and traffic control at all times.”See alsoMotorbike newsMV AgustaMV Agusta To Unveil Two New ADVs at EICMA Work is being carried out from 6.30am to 3.30pm on weekdays, with traffic reduced to one lane during work hours. Transport for NSW thanks motorists for their patience during this time. For the latest traffic updates download the Live Traffic NSW App, visit livetraffic.com or call 132 701.